How to Properly "Trim and smooth" jagged edges of the map?

[Cute Wolf]

well, it was actually a minor issue, but everytime I scroll through the campaign map I just made, the coastlines are started to blink and get jagged edges....
what should I do to tone down that? I allready try with map_heights, but with no good result...

anyone can help?

[Myrddraal]

So your map_heights.tga has smooth edges to the coasts? You haven't resized map_regions to give you the shore outline? Have you tried making sure that all coasts are very low lying?

Just a couple of ideas. The coasts will always be a little bit jagged.

[Cute Wolf]

yupz, allready try with 0 0 0 as coastal tile, followed by 2 2 2 and 5 5 5, but as far as textures in map are concerned, they are still jagged... anyhow, it was somoother now, after setting new map_heights for them... thanks for the info that map edges will always be jagged.

[Myrddraal]

Could we see a screenshot of the relevant part of you map_heights, just to be sure? I also don't see any waves on your map, perhaps this is part of the same problem? Have you turned off any graphics options?

[Cute Wolf]

oh yeah, actually, it was detected when I scroll through the map, the beach was gone wavy.... how to capture video in RTW then ?

[Myrddraal]

Fraps or some screen capture software like it, but I am curious to see a pic of that section of your map_heights