Since my case is built-in water cooled, after the pump went I've been left with a big hunk of metal. The manufacturer is out of business, so I'm going to buy a new case. I've never done such an in-depth job before, so I am a bit nervous. Any tips?
Since my case is built-in water cooled, after the pump went I've been left with a big hunk of metal. The manufacturer is out of business, so I'm going to buy a new case. I've never done such an in-depth job before, so I am a bit nervous. Any tips?
"That rifle hanging on the wall of the working-class flat or labourer's cottage is the symbol of democracy. It is our job to see that it stays there."
-Eric "George Orwell" Blair
"If the policy of the government, upon vital questions affecting the whole people, is to be irrevocably fixed by decisions of the Supreme Court...the people will have ceased to be their own rulers, having to that extent practically resigned the government into the hands of that eminent tribunal."
(Lincoln's First Inaugural Address, 1861).
ΜΟΛΩΝ ΛΑΒΕ
I find a tumbler of brandy steadies the nerves. My doctor friend swears by a stout glass before surgery, and he's got a positive survival rate!
Seriously - are you buying a new water-cooled case? I would suggest otherwise, as air cooled is much easier to maintain - as you have found out. Or are you talking about taking your goods out of the old case and putting them into the new? I'm afraid I'm not much help with that either.
Of course draining the broken system completely before attempting part removal would be good - though I'm not sure how you'd do that. Do you still have the manual?
You could try replacing the pump, since similar ones may be made, or an old one found on ebay.
CR
Ja Mata, Tosa.
The poorest man may in his cottage bid defiance to all the forces of the Crown. It may be frail; its roof may shake; the wind may blow through it; the storm may enter; the rain may enter; but the King of England cannot enter – all his force dares not cross the threshold of the ruined tenement! - William Pitt the Elder
I instantly realized the limitations of a built in water cooled case. I'd most likely try it again, but modular rather than built in. I've gotta say, the case lasted for 2 years and there was barely any dust in the case with only one or two graphics card air sprays. The system was silent and cold, but the inherent limitations were game ending... literally.
I went with the Coolermaster HAF 932 Full for the case:
http://www.newegg.com/Product/Produc...82E16811119160
I went with the Coolermaster Hyper-N 520 for CPU fan and heatsink:
http://www.newegg.com/Product/Produc...82E16835103057
Grand total: $157 - $10 mail-in rebate.
Last edited by ICantSpellDawg; 02-05-2011 at 15:41.
"That rifle hanging on the wall of the working-class flat or labourer's cottage is the symbol of democracy. It is our job to see that it stays there."
-Eric "George Orwell" Blair
"If the policy of the government, upon vital questions affecting the whole people, is to be irrevocably fixed by decisions of the Supreme Court...the people will have ceased to be their own rulers, having to that extent practically resigned the government into the hands of that eminent tribunal."
(Lincoln's First Inaugural Address, 1861).
ΜΟΛΩΝ ΛΑΒΕ
I have to recommend my Silverstone Fortress 02 case, it is spectactularly quiet and solidly built:
http://www.silverstonetek.com/produc...=FT02&area=usa
However, if you must have a full watercooling rig then apparently the Corsair 700D/800D cases are supposed to be more appropriate.
I use a Corasir H50 all-in-one water CPU cooler with my FT02 and it works fine, but that is a different beast.
Furunculus Maneuver: Adopt a highly logical position on a controversial subject where you cannot disagree with the merits of the proposal, only disagree with an opinion based on fundamental values. - Beskar
Bookmarks