Question on Map Editing

[HunkinElvis]

How do I place a bridge over the water? I can't get my army to go over the bridge. Is it because of the ground level?

[Orda Khan]

Please explain in a bit more detail.
The bridge model has to be able to span the the river, drop the camera angle to make sure the bridge actually touches the land on each side of the river.

Also, be aware that river maps should have the river run left to right across the map in order to make sure there are no deployment issues or other irregularities.

Adding water to your maps is fraught with strange consequences, so err on the side of basic as opposed to to a complicated map.

Good luck

........Orda

[PaolinoPaperino]

sometimes, when the ground level is too low it looks like ground, but the computer recognise it as water, so no direct line and troops does not find the bridge. Try to follow Orda's tip, and if you are sure bridge touches both sides, increase it a bit the ground on the lower side.
On the other side I remember a limit about 4 bridges on map...

[Drisos]

when i tried to include water in a map, units could walk in it, so that they were invisible>>>weird!!