Results 1 to 15 of 15

Thread: Roman unitsize

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1

    Default Roman unitsize

    This post is about some questions/suggestions for the unit text file. I do not mean this as an attack on anybody, but I just want to share some thoughts on the roman units, which are the only one I been studying so far, since they are my biggest interest, and the faction I by far now the most about. The following numbers are all on large unitsize.

    First a couple of minor things: I have removed officer and standard bearer from early triarii, because they destroys the unbroken front that is needed for phalanxes to work, and it might be worth considering doing this for all units that have the ability to form a phalanx. (If it is not hardcoded, it would be even better to place officers to the rear of the phalanx formation, so they don’t disturb the “wall” of spears)

    The late Principes have the attribute of being a mercenary unit. Unless there are some ingame reasons I don’t know about, I don’t think they should be a mercenary unit, since they never was in real life.

    My biggest issue is with the numbers of soldiers in the roman units after the Marian reforms. The following units all suddenly consist of 100 men deployed in 6 lines, in contrast to pre Marian units who consist of 80 men in 4 lines. Cohortes Praetoriana, Cohortes Imperatoria, Cohortes Reformata and Cohortes Evocata are all 100 men units, and I don’t know of any historic evidence that implies, that such a change in the standard centurie had taken place, and I really think that these units should go back to 80 men in 4 lines, with the appropriate adjustments in training and upkeep. I haven’t found any gameplay reasons for the enlargement of the standard unitsize for the “ordinary” roman infantry.

    The Levantine Saggitarius Auxilia has 120 men in a unit, which in my opinion make them way to strong compared to other archer units, who all have between 60 and 80 men in a unit.

    I have therefore cut all these units to 80 men and made the necessary adjustments in prize.

    But I would very much like to hear the reasons for the high numbers of men in the above mentioned units, both out of curiosity, but also because I don’t want to upset the balance of the gameplay, with changes, that EB already have tested, and that have proven for some reason not to work properly. I guess that about covers it for now!

  2. #2

    Default Re: Roman unitsize

    Quote Originally Posted by Crac des Chevaliers
    First a couple of minor things: I have removed officer and standard bearer from early triarii, because they destroys the unbroken front that is needed for phalanxes to work, and it might be worth considering doing this for all units that have the ability to form a phalanx. (If it is not hardcoded, it would be even better to place officers to the rear of the phalanx formation, so they don’t disturb the “wall” of spears)
    Would be great but that is hardcoded - either officer on the side or no officer at all

    Quote Originally Posted by Crac des Chevaliers
    The late Principes have the attribute of being a mercenary unit. Unless there are some ingame reasons I don’t know about, I don’t think they should be a mercenary unit, since they never was in real life.
    It is either mistake or it is needed for model sharing purposes, but it do not make Principes available as mercenaries. To be typical merc's they have to appear in special txt file (I do not remember name, sorry)

    EB ship system destroyer and Makedonia FC

  3. #3
    EB Token Radical Member QwertyMIDX's Avatar
    Join Date
    Jan 2005
    Location
    Providence, Rhode Island
    Posts
    5,898

    Default Re: Roman unitsize

    The jump in unit size was decided to show the change from manipular organization to one based on cohorts (which are bigger than maniples). The number of men in the Levantine Saggitarius Auxilia unit should be 80, I'll fix that in the next build. Also you're paying per man in each unit, so if you want smaller or bigger units you should adjust the costs to reflect your changes.

    O'ETAIPOS is right about the mercenary_unit attribute, it's entirely a model sharing issue. The late principes model is shared with another roman unit (late hastati I think) and if you take off that attribute one unit will have the wrong skin. RTW only allows one skin per unit per faction and using the mercenary_unit attribute is just a way to have another skin on the same model. It shouldn't affect gameplay at all and it doesn't make the principes hireable anywhere.
    History is for the future not the past. The dead don't read.


    Operam et vitam do Europae Barbarorum.

    History does not repeat itself. The historians repeat one another. - Max Beerbohm

  4. #4

    Default Re: Roman unitsize

    Thanks to both O’ETAIPOS and QwertyMIDX for the very quick reply. The part about the mercenary entry now makes perfect sense.

    For the Levantine Saggitarius Auxilia I have changed the prize to 1021 and upkeep to 255. I hope that is about right to keep the balance in unit cost.

    Have you discussed the possibility of removing all officers and standard-bearers from units with the ability to form a phalanx? I have found that it improves on the effectiveness when there isn’t “holes” in the line that the enemy can move through. And if I am facing phalanx units the ai has enough trouble maintaining an unbroken line without the addition of holes coursed by officers!

    About the increase in numbers in the roman infantry, I can’t say that I agree. I know that the roman army went from a manipular system to one based on cohorts. The problem is that the basic manipel was two centuries strong and the cohort numbered 6. This doesn’t change the fact that the standard centurie had the same number of soldiers - around 80. The overall number of soldiers in the legion also didn’t change (until later) and the cohort system was more a tactically change to make the legion more uniform and flexible on the battlefield and capable of better operating in smaller units. Therefore, I don’t think that an increase in numbers from 80 to 100 is a good way of reflecting these changes. The result of the change in system is already illustrated through the chances from principes/hastate/triarii to cohorts reformata as the main battle soldier and the rest must be up to player tactics on the battlefield. In regard to gameplay, I find that the increase in numbers gives the Romans an unfair advantage - since most other heavy infantry with similar fighting styles only number 80. Instead the stats for roman post-Marian infantry could get a slight increase to reflect their status as some of the best heavy infantry in the ancient world at this time and to maintain the overall balance with the fever men per unit.

    This is not a big problem since it can rather easily be modded by the player (even I have figured out who to do it!) but I still think it might be worth considering again if the 80 soldiers per unit isn’t a better solution with the appropriate changes to cost and stats. I realize that it is all a part of a bigger and complex picture to keep all units stats and prize in balance - but as a big fan of both the Romans and a lot of the changes EB has made to the original game I just wanted voice my opinion. I guess we all have an opinion on making the perfect game so I appreciate EB members and others taking time to read all this.

  5. #5
    EB Token Radical Member QwertyMIDX's Avatar
    Join Date
    Jan 2005
    Location
    Providence, Rhode Island
    Posts
    5,898

    Default Re: Roman unitsize

    I will certinly bring up your issues with the rest of the team and see what they think. As a side note, be careful not to get trapped in the idea that 1 man in RTW actually represents 1 man, that's not the way EB delt with the issue.
    History is for the future not the past. The dead don't read.


    Operam et vitam do Europae Barbarorum.

    History does not repeat itself. The historians repeat one another. - Max Beerbohm

  6. #6

    Default Re: Roman unitsize

    I had a thought about your phalanx oficer problem, but I don't know if it will wrok for sure. I was thinking why not jsut skin the phalanx oficers as normal phalangites. Like I said don't know if that will work, but if it dose it should not be that hard, right?
    "I don't give a damn for a man that can't spell a word more than one way." Mark Twain.

  7. #7

    Default Re: Roman unitsize

    Quote Originally Posted by QwertyMIDX
    As a side note, be careful not to get trapped in the idea that 1 man in RTW actually represents 1 man, that's not the way EB delt with the issue.
    This is an excellent point to consider Crac des Chevaliers. Remember that a unit is only a representation of a much larger group of soldiers. In-game, a 20 unit stack, numbering roughly 4000 strong (obviosly it will vary depending on unit sizes, ammount of units, etc.), and that is meant to represent an entire army. Just as a unit of ships have "only" 52 soldiers. This is not supposed to imply that a fleet would only contain 52 men, of course. It just simplifies things for the game. So I don't think it is a big deal whether or not a unit size is historically accurate (although I am sure every effort is made by the EB team to do so), considering the engine and the limitation on the number of soldiers in the game does not constitute for a completely historically accurate game.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Single Sign On provided by vBSSO