Reinforcments

[MoKus]

I note the word try. Does that mean you have not been able to move / reset it ?

No. I can set the flag in everyplace on map. The pointer before setting is however red.

My question ( marked Blank (sic) in your quote ) was an observation re your comment. When the pointer shows as RED you are generally NOT allowed to click on the Map at that point ( for whatever reason ). Having never tried to place the Reinforcements Flag in the "Red Zone" of the Map, I am uncertain if the game will or will not allow it. If it does, then that is likely to be the source of your problem.

That is strange because the pointer is red yet I can set the flag on everyplace that I want.

[ NB: The Red Zone referred to here is the area of the map that you are not allowed to move to ( unless Routing or Withdrawing off the board ). It's also the point where your troops will stop chasing enemy units that are Routing or Withdrawing, as those troops can no longer be Rallied by the AI. ]

I see. I normally click on somewhere in center of map.

Is the Reinforcement button "Greyed Out" or Coloured ?

Colored.

As advised previously ( by Stazi ), If the former, there are no reinforcements available. If you have more than 16 Troop units in the province, the button should however, be Coloured.

I have more that 16 units in the province. I see that I have free spot in middle of battle. I first set the flag and then click on reinforcement button but nothing happens.

[ As stated by the others previously, a Reinforcement unit cannot enter until one of the original 16 units leaves the Map. Pressing on the Reinforcements Button automatically enters the Reinforcement onto the bottom of the Screen in the Units area, once the on map units are 15 or less. So you wait until the units drop to 15 ( or less ) and then press the Reinforcements button. You can see when the units total drops, as a space appears on the extreme right of the units area. However, the reinforcement may not appear in the obvious vacated slot ( that extreme right hand one ) but is likely to appear amongst the other unit labels ( perchance in the actual slot vacated by the leaving unit ? ). That point certainly confuses me for several seconds whenever I bring a unit on. ]

I have free spot yet I cannot reinforce.

Hmmm. Late thought - is your reinforcement unit a Siege unit ? These units CANNOT be brought on as Reinforcements ( as DRONE said... ) !

No they are not siege unit.